Water's unexplained properties
In a closed system where volume is held constant, there is a direct relationship between Pressure and Temperature. In a direct relationship, one variable follows . Yes, at constant density, the pressure increases as the temperature does: Temperature vs Pressure vs Density - Water. For example, having. Water temperature is 20 degrees celsius (room temp) in the pipe originally, and a pressure of "1". Then the city increases water pressure to "2".
Boiling point - Wikipedia
List of elements by boiling point The element with the lowest boiling point is helium. Both the boiling points of rhenium and tungsten exceed K at standard pressure ; because it is difficult to measure extreme temperatures precisely without bias, both have been cited in the literature as having the higher boiling point.
A given pure compound has only one normal boiling point, if any, and a compound's normal boiling point and melting point can serve as characteristic physical properties for that compound, listed in reference books. The higher a compound's normal boiling point, the less volatile that compound is overall, and conversely, the lower a compound's normal boiling point, the more volatile that compound is overall.
- Water's Unexpected Properties
- Pressure, temperature, and volume relation in liquids
- Vapour pressure of water
Some compounds decompose at higher temperatures before reaching their normal boiling point, or sometimes even their melting point. For a stable compound, the boiling point ranges from its triple point to its critical pointdepending on the external pressure. Beyond its triple point, a compound's normal boiling point, if any, is higher than its melting point.
The proportionality between the logarithm of the vapor pressure and the reciprocal temperature for liquid water is near constant for its complete span from supercooled water through to the critical point, as shown below with data from .
The red line follows the experimental or theoretical data whereas the underlying blue line is the fitted straight line relationship. The logarithm of the vapor pressure and the reciprocal temperature for liquid water ] Pressure-density relationship The density of liquid water tends towards an integral 6th power relationship with respect to pressure.
This relationship is shown below P' is the scaled pressure, that is, the left side of the above expression as the dashed lines, with the colored lines being the experimental data.
The best fit is thus around the compressibility minimum at The extrapolated density at zero T and P is 1. Densities of water tend towards a 6th power law dependent on temperature and pressure As this power law does not obey the rule of thumb that candidate power laws should exhibit an approximately linear relationship on a log-log plot over at least two orders of magnitude in both the x-axes and y-axes [ ], it seems likely that this relationship is purely empirical.
The friendliest, high quality science and math community on the planet! Everyone who loves science is here!
Pressure, temperature, and volume relation in liquids Jun 26, 1 physical1 Physics books and websites are full of Ideal Gas info and solutions when it comes to relating pressure, volume, and temperature. For example let us say a liquid in a horizontal pipe is under double the static pressure than it was originally.Saturation Temperature & Saturation Pressure
By static pressure I do not mean hydrostatic - I mean static as in the other pressure factor of water not sure what it is called. Your water company decides, whelp, let's increase the city water pressure! Say originally we had a horizontal copper pipe full of water. At the one end of the pipe is a tap that is closed.
At the other end of the pipe is the incoming city water company city pressure. Water temperature is 20 degrees celsius room temp in the pipe originally, and a pressure of "1".